UP USB2.0 to m-SATA Converter board

UP USB2.0 to m-SATA Converter board with mounting accessory, support SATA I/II/III m-SATA SSD, fully ROHS/REACH compliant.
(no additional power supply required)

Supports SATA III, SATA II and SATA I mSATA SSD
- Compliant with Serial ATA Specification Revision 2.6
- Supports Serial ATA transfer rate of 6.0 Gbps
- Supports ATA/ATAPI Packet Command Set
- Supports ATA/ATAPI LBA 48 Addressing mode
- Compliant with Universal Serial Bus Specification Revision 2.0 (Data Rate
1.5/12/480 Mbps)
- Compliant with Open Host Controller Interface Specification for USB Rev 1.0a
- Compliant with Enhanced Host Controller Interface Specification for USB Rev
0.95
- Both USB micro-B connector and USB 5Pin Pinheader on board for UP board
connection
- USB2.0 5Pin Pin Header Assignment: 5V, D-, D+, NC, GND

- Jumper selection either power wafer of external 5V sufficient power or 5V USB
- bus power to PCBA & mSATA SSD
- On board activity LED for mSATA accessing
- Includes 2 mSATA screws for the retention of mSATA module
- Includes HAT mounting accessory of standoff & nut & screw
- Fully RoHS compliant